Nestlé uses a Knoll double screw pump
Nestlé uses a double screw pump from Knoll, to plasticise large blocks of chocolate.
After adding cocoa paste, cocoa butter, powdered milk and sugar, the mix is heated to a temperature of over 40°C and then slowly cooled to give the chocolate its delicate smoothness, smooth texture and shelf stability. At Nestlé, the chocolate is poured into blocks measuring 500 x 300 x 150mm and stored in a cooling room at 12°C before being processed into various chocolate fillings.
To be able to mix this chocolate paste with nuts, raisins or other ingredients, the hard blocks must first be softened. In the past, they were stored in a warming room for several days at 28°C for this purpose.
Today, chocolate pralines take less time to make. Using pump technology, the 12°C chocolate blocks can now be processed directly, thus eliminating the need for preheating in the warming room and all the transportation this involves. This makes the production process more flexible, timesaving and efficient.
The hard blocks of chocolate are transformed into a viscous mass which can subsequently be conveyed even large distances to the extruder. The extruder squirts the chocolate filling into the desired shape before the confectionery is finally coated with chocolate and decorated, then cooled and finally packaged.
At the heart of a double screw pump is a full screw and an open screw which intermesh. This produces a forced-feed effect, so that everything which enters the pump is reliably pushed out. Formation of rolls is prevented by the interlocking of the screws. Since the air in the screws is able to flow out backwards through a narrow gap, the medium is conveyed continuously and free from air. This is an important factor if the medium is to be cut, processed or dispensed straight after leaving the pressure nozzle. Knoll has positioned a gear between the drive and the actual pump for synchronising the screws. That guarantees contact-free intermeshing, minimising wear and contributing to the dry-run safe operation of the pump. The pump is available with plastic or stainless steel screws; the latter are recommended for processing blocks of chocolate. Plastic screws – made of food-compatible polyamide – are ideal for use at extremely low temperatures, ie for processing solid blocks of product at temperatures as low as -18°C. In this case, the pump is preceded by a reducer which breaks the large blocks into pieces 10 x 10 cm in size before they drop into the double screw pump.
The pump is easy to clean. The drive unit can be removed from the pump housing on a rail system, complete with the screws. The screws and housing are then exposed and can be manually cleaned with a steam blaster or similar. Very little residue remains in the pump after the conveyance operation. This is because the geometry of the pump housing is so precisely measured that the gap is just a few tenths of a millimetre.
A non-contact safety switch provides for reliable stoppage of the drive when the pressure nozzle is opened (this can be done using a hinge). The pump is designed for the food industry and is therefore fully compliant with FDA requirements. The housing parts and screws are made of high-quality stainless steel or ultra-hard polyamide 6. This plastic is food compatible and resistant to acids, alkalis and oils. Water is also unable to damage it, for the polyamide 6 used does not swell. Compared to stainless steel, the plastic has the advantage of a substantially lower weight.
